Friday, July 27, 2012

Day 2 Life Learner

 Day 2 we went back to Nancy's studio to clean off our glass. Using a wet sander we cleaned any remaining compound off our glass pieces.
 Next step was to glue our glass pieces to a metal back.
 If you look closely at my glass you may notice there is white contact paper over the piece. Using a knife I cut out my design. The dots were applied with glue. I then sand blasted or etched the glass that you see.


Etching completed the next step is to glue to metal. Almost done.

No comments:

Post a Comment


Blog Widget by LinkWithin